The Festool Right Angle and Eccentric Chucks provide the means of drilling and driving screws in places where previously only specialized drills could reach.

These FastFix Chucks not only install and remove quickly and easily without tools but they are also "clocking". They can be installed at any location aroung the drill axis in angular increments of 22-1/2 degrees. That makes 16 discrete locations to optimize your angle of attack.

The images below show some typical configurations using these chucks. This section is not intended to show every possible combination, just a representative sampling.

This image shows the T 15 +3 with the Right Angle Chuck and a 25 mm drive bit. This is for the tightest spots...

This one is the T 15 +3 with the Right Angle Chuck, Centrotec Chuck and a Centrotec Drive Bit:

Here is the T 15 +3 with the Right Angle Chuck, Centrotec Chuck, a Centrotec Magnetic Bit Holder and a 25 mm drive bit:

Here is the T 15 +3 with the Right Angle Chuck, Centrotec Chuck, a Centrotec Locking Magnetic Bit Holder and a 25 mm drive bit:

Here is the T 15 +3 with the Right Angle Chuck, the Keyless Jacobs-style Chuck, and a drill bit:

The T 15 +3 with the Right Angle Chuck, Centrotec Chuck and a Centrotec Drill Bit:

The T 15 +3 with with the Eccentric Chuck and a 25 mm drive bit. This chuck locks on the bit and can be used similarly to the Locking Bit Holder.

Return to "Festool Cordless Drill Accessories"